Mona-Guard WD - Clear

Clear Wood Sealer
Availability: In Stock

£27.72

Ex Tax: £23.10

Available Options

* Size:

Qty:

Description Uses Advantages Technical Info Data Sheet Health & Safety

Mona-Guard WD - Clear is a unique product based upon hydrophobic and oleophobic chemistry that impregnates the fibres to provide a clear, invisible protection of bare and renovated wood. Mona-Guard WD - Clear is designed to slow the ageing of the wood and makes it impermeable to water, grease and stains. Mona-Guard WD - Clear will reduce the maintainance required within its life cycle, maintaining a cleaner and longer lasting appearance.

For use internally and externally to all bare woods where protection is desired, such as oak, pine, spruce, Douglas fir, pressure-treated wood etc. :

Decking
Fencing
Weatherboarding
Panelling / shuttering
Joinery - kitchen worktops etc
Garden furniture
All above ground wood substrates

Excellent water repellence
Excellent resistance to oil penetration.
Excellent Stain Resistance
Resistant to Dirt and Pollution
Resistant to Weathering & delays aging
Prevents moss and algea forming
Permeable to Water Vapour (breathable)
Slows down ageing of wood
UV, Chemical & abrasion resistant
Reduces maintenance required
Invisible finish obtained - Grains maintained
Solvent free
Envirnomentally friendly
up to 10 years product performance

Technical Support:

Monaseal provides a technical advisory service for on-site assistance and advice on product selection, evaluation trials and application equipment.

Product Information:

Colour Range	Invisible
Preparation	Ensure surface to be treated is clean, not contaminated and dry.
Application	2 coat application by means of Low pressure spray, brush or roller
Coverage	3-6 m2/Ltr depending on substrate type
Curing Time	Touch dry 4-6 Hrs Fully cure 48 Hrs
Equipment Care	Clean with water immediately after use.
Pack Size	5 or 25 Ltrs drums, and 1000 Ltrs IBC
Storage	Store in dry condictions at temperatures between + 5 & + 35 degree C
Shelf Life	12 months in original sealed container
HSE	See MSDS

SYSTEM RECOMMENDATIONS

SUBSTRATE PREPARATION

New wood and in general - the surface must be sound, clean, dry, free from frost, laitance, oil, grease and all dust, loose and friable materials must be completely removed from surfaces before application of Mona-Guard WD - Clear

Resinous or greyed wood: clean with suitable revitalizer, rinse thoroughly, clean off all dust and dry the wood.
Damaged wood: sand down to bare wood, clean off all dust and dry the wood. It is recommended to hover all residual dust left from sanding process.

NOTE - Mona-Guard WD - Clear cannot prevent the wood from splitting if it is exposed to excessive variations of hygrometry.

Limitations of Use

The treatment may be ineffective in the following cases:

On varnished, waxed, heat treated, polished, highly brushed, retified, modified or THT (high-temperature treatment) woods.
On damp wood (moisture content > 16%).
Where micro-organisms or insects are present (pretreatment necessary).
Poor application, preparation and quiality of substrate type
On sapwood.
Untested application on exotic or resinous wood.
On wood that has undergone a fire-resistance treatment.
On sharp edges (sharp edges should preferably be rounded to ensure continuity of product and thus avoid breaks in coverage).
On floors.
Ends, cuts, drill holes, etc. not saturated with product.

Guide Line Coverage Rates

Wood type

5m2/litre applied in 2 coats

*Please note - Monaseal recommend a small trial area to ensure correct application levels are used to obtain the required performance properties subjected to the differing porosity levels of porous building materials.

Mona-Guard WD Clear Data Sheet - CLICK HERE

Mona-Guard WD Clear MSDS - CLICK HERE

Tags: Protection, 1L